Dot config with Mullvad not working
Hi Have tried to setup secure DNS DoT with Mullvad on the BE600.
The using 194.242.2.6 with DoT unfortunately I can not post the dns info
When configured the router will not work yet I have this working on other routers with these settings no issue.
I have tried ControlD
76.76.2.11
DoT Unfortunately cannot post the dns info
ControlD works no issue on the be600 and other routers no issue.
Would anyone know what the issue is and why / what I can do to get Mullvad working on the be600.
Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello @57AY ,
Welcome to our community.
Mullvad may require a specific server name (SNI) in addition to the IP address. Double-check Mullvad's documentation for the correct DoT configuration.
For step-by-step guidance with images, visit: How to configure DoH/DoT on TP-Link Wireless router
If ControlD works but Mullvad does not, it could be due to differences in how each provider handles DoT connections or the need for a specific server name. Try entering both the IP address and the server name if possible. If issues persist, consider reaching out to Mullvad support for their recommended DoT settings.
Best Regards.
- Copy Link
- Report Inappropriate Content
Hello @57AY ,
Welcome to our community.
Mullvad may require a specific server name (SNI) in addition to the IP address. Double-check Mullvad's documentation for the correct DoT configuration.
For step-by-step guidance with images, visit: How to configure DoH/DoT on TP-Link Wireless router
If ControlD works but Mullvad does not, it could be due to differences in how each provider handles DoT connections or the need for a specific server name. Try entering both the IP address and the server name if possible. If issues persist, consider reaching out to Mullvad support for their recommended DoT settings.
Best Regards.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 292
Replies: 1
Voters 0
No one has voted for it yet.