VR2100 Fireware Update - Issue after Install

VR2100 Fireware Update - Issue after Install

VR2100 Fireware Update - Issue after Install
VR2100 Fireware Update - Issue after Install
Friday
Model: Archer VR2100  
Hardware Version: V1
Firmware Version: 1.9.0.0.9.1 v009e 0 Build 240903 13195n

  After a undate to the firmware version shown above, the Internet status on the network map page has started to show a rotating circle all of the time and below that the internet status is showing "Detecting"   Details below the Internet Status field are correct and yes there is an internet connection is working.  A reboot did not fix the problem neither did a complete power cycle.  Anybody else having the same issue?  Thanks

  0      
  0      
#1
Options
2 Reply
Re:VR2100 Fireware Update - Issue after Install
Tuesday

  @vfrgpz 

 

Try the following:

Edit your PPPoE connection and set a custom DNS servers like in the screenshot bellow and test how it goes.

 

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  0  
  0  
#2
Options
Re:VR2100 Fireware Update - Issue after Install
46 minutes ago

  @terziyski Thanks I will give it a go, when I get a free moment, to see if the connection is registered as stable.  I will have to revert to the DNS used,as my ISP provides Parental controls for me and I believe only works if I use their DNS.

Thanks

  0  
  0  
#3
Options