ER605W Disable NAT
Hello, I'm would like to disable NAT on ER605W for LAN to LAN connection and I have my own gateway doing NAT to the internet. But I have no Disable NAT option.
Internet ----> OpenWrt [LAN] ----> ER605W
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
goto network config and nat
if it is not there, your router does not support disable nat.
- Copy Link
- Report Inappropriate Content
@MR.S It's not there.
- Copy Link
- Report Inappropriate Content
Ok, its look like that this is not an option on your router. I know its on ER605v2 and up to ER8411,
- Copy Link
- Report Inappropriate Content
@MR.S Ah alright, good to know. Could the future version of the software gives the option to do that for this router ? Also can this router configure just as a WiFi AP without doing any routing or NAT ?
- Copy Link
- Report Inappropriate Content
The Omada wireless gateways (ER605W and ER706W) do not have an AP mode that you sometimes have in other routers.
- Copy Link
- Report Inappropriate Content
Will there be any updates? I don't know. Can you use a router as an access point? Yes, if you have another router in the network, disconnect the WAN, connect only to the LAN port, disable DHCP if you have DHCP on another router.
Of course you have to make sure that it is not the same IP on both routers, so change the ER605 to something else in the same IP network as the other router.
The ER605W will still be a router, but since you only connect to the LAN, it will behave as an access point.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 83
Replies: 6
Voters 0
No one has voted for it yet.