@punda Connecting 500 IP cameras requires careful VLAN planning and proper bandwidth management on the OLT bridge setup. You’ll need to separate traffic using VLANs to avoid congestion and improve network stability. Proper switch configuration and IP planning are also very important for large-scale camera deployment. I also came across Jjrs game download while checking similar networking and system setup discussions.

  @elenagrace49 

please help in this how to do it i need full detail about it

Hi,  @punda 
If you have more than 500 cameras connected to the same network, we would recommend segmenting them into 3 to 4 VLANs, with roughly 100+ cameras allocated to each VLAN to improve overall network stability.

You will first need to configure VLANs and assign corresponding VLAN IDs on your router, then set up the required Trunk ports and Access ports according to your actual network topology.

As we do not have full details of your specific network topology, we can only provide relevant materials for your reference as follows (for whole Omada devices topology):How to configure VLAN with Omada Network v6 | Omada Network Support

  @Nathan-TP 

sir. load balancer is required for this or not and 

I HAVE

SG3428 SWITCH

TL470T+ LOAD BALANCER

DS-P7001-04 OLT

OC300 CONTROLLER

PLEASE SUGEST BEST TOPOLOGY FOR CONNECTING 

PLEASE TELL ME THAT

CONFIGURATION OF VLAN I HAVE TO DO ON BOTH OLT AND SWITCH OR ONLY SWITCH