Hello. Would it be possible to request a feature to show the Ethernet link speed of Mesh Nodes and connected devices. Currently if a Mesh Node is operating in wireless mode you can see a signal strength. However, when connected via Ethernet there is nothing. It would be good to know the link speed and duplex setting that the device is connected at... 2500/FULL, 1000/FULL, 100/HALF, etc.

The same applies to wireless connected devices - the app shows a signal strength. However, anything connected via Ethernet does not get a link speed/duplex setting shown.

This would be a useful troubleshooting tool to understand any cabling issues within a network.

I would also like to see the same feature for the Deco X50 V1 (firmware 1.8.0) as I manage a couple of networks based on these devices for family.

Many Thanks...