Port Forwarding Archer MR200
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Port Forwarding Archer MR200
Model :
Hardware Version :
Firmware Version :
ISP :
For other TP LINK router, I can port forward but for Archer MR200 I m not able to do so.
Is it because it is NAT Forwarding?
Please Advise.
Hardware Version :
Firmware Version :
ISP :
For other TP LINK router, I can port forward but for Archer MR200 I m not able to do so.
Is it because it is NAT Forwarding?
Please Advise.
Re:Port Forwarding Archer MR200
Step 1 Log into the router’s web management page:
How do I log into the web-based Utility (Management Page) of TP-Link wireless router?
Step 2
Click Forwarding->Virtual Servers on the left side, and then click Add New… button.
Step 3
Type the Service port which you want to open and the IP Address of your device that you want to open the port for; Select Protocol to TCP, UDP or ALL; Change Status to Enabled
How do I log into the web-based Utility (Management Page) of TP-Link wireless router?
Step 2
Click Forwarding->Virtual Servers on the left side, and then click Add New… button.
Step 3
Type the Service port which you want to open and the IP Address of your device that you want to open the port for; Select Protocol to TCP, UDP or ALL; Change Status to Enabled
