archer mr200 - connection interruptions
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
archer mr200 - connection interruptions
Model :
Hardware Version :
Firmware Version :
ISP :
I bought tp-link archer mr200 to have mobile (austrian telekom a1 sim) internet in my house.
In principle, the router is really nice and fast to furnish - however, I have continuous interruptions. In irregular intervals (sometimes after 2 minutes, sometimes after 10 minutes, sometimes after an hour) I cannot connect to the internet with my clients (handy, laptop) for certain time (20 seconds to minute) - but the archer says that he connection is fine and the diagnostic is confirmed. (While I can not connect to the internet from the client I can connect to the webinterface of archer without problems)
I have tried all firmwares - everywhere the same problem.
http://static.tp-link.com/res/down/soft/Archer_MR200(EU)_V1_160310.zip
http://static.tp-link.com/res/down/soft/Archer_MR200(EU)_V1_160412.zip
http://tp-link-support.de/firmware/Archer_MR200/Archer_MR200v1_160707.WANfailover3G4G.beta.zip
The problem occurs, no matter whether I am connected by wlan or by cable to the archer.
Also a sim-card exchange shows the same problem - although exactly the same sim card in a mobile phone which was exactly on the same place had no problems.
Signal strength is 100% - which can not be synonymous.
Has anyone else ideas?
Hardware Version :
Firmware Version :
ISP :
I bought tp-link archer mr200 to have mobile (austrian telekom a1 sim) internet in my house.
In principle, the router is really nice and fast to furnish - however, I have continuous interruptions. In irregular intervals (sometimes after 2 minutes, sometimes after 10 minutes, sometimes after an hour) I cannot connect to the internet with my clients (handy, laptop) for certain time (20 seconds to minute) - but the archer says that he connection is fine and the diagnostic is confirmed. (While I can not connect to the internet from the client I can connect to the webinterface of archer without problems)
I have tried all firmwares - everywhere the same problem.
http://static.tp-link.com/res/down/soft/Archer_MR200(EU)_V1_160310.zip
http://static.tp-link.com/res/down/soft/Archer_MR200(EU)_V1_160412.zip
http://tp-link-support.de/firmware/Archer_MR200/Archer_MR200v1_160707.WANfailover3G4G.beta.zip
The problem occurs, no matter whether I am connected by wlan or by cable to the archer.
Also a sim-card exchange shows the same problem - although exactly the same sim card in a mobile phone which was exactly on the same place had no problems.
Signal strength is 100% - which can not be synonymous.
Has anyone else ideas?
