TL-MR3020 doesn't start in AP mode, even if reset.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-MR3020 doesn't start in AP mode, even if reset.
Model : TL-MR3020
Hardware Version :
Firmware Version : 3.12.11 Build 120320 Rel.42138n
ISP :
I don't use this router for some months... I connected it the other day and it seems that it was reset.
Doesn't care, I can configure it again... but my computer can't connect to the router.
So, I reset it again... and nothing. If I change it to 3G or WISP, it does connect.
I connected with ethernet and again, if it is 3G or WISP, it connects. If AP, it doesn't.
I changed SSID and Security config... but it does the same.
Is AP mode dead?
Hardware Version :
Firmware Version : 3.12.11 Build 120320 Rel.42138n
ISP :
I don't use this router for some months... I connected it the other day and it seems that it was reset.
Doesn't care, I can configure it again... but my computer can't connect to the router.
So, I reset it again... and nothing. If I change it to 3G or WISP, it does connect.
I connected with ethernet and again, if it is 3G or WISP, it connects. If AP, it doesn't.
I changed SSID and Security config... but it does the same.
Is AP mode dead?
