Model :

Hardware Version :

Firmware Version :

ISP :

Firmware Version: 0.9.1 1.1 v004a.0 Build 160905 Rel.60037n (which I got from http://uk.tp-link.com/download/Archer-MR200.html#Firmware)
Hardware Version: Archer MR200 v1 00000000

Hi,

My only problem with the Archer MR200 so far is that the static routes to my other router's subnet isn't working after the MR200 was power cycled.
The static route entry still exists, but its not working, and when I toggle the lightbulb in the Enable column it fails to enable it. When I then go and edit the whole row it works again.

Under the "Advanced Routing" I have the LTE interface selected as the "WAN Interface".
I then added a single static route:





Then under "LAN Settings" I have it configured as:




Should I rather send this to the TP-Link Technical Support instead?

Aside from this issue, I also find it strange that the available firmware on my country's webpage is very old and different: http://www.tp-link.co.za/download/Archer-MR200.html#Firmware

Thank you in advance,
Chris