TP-Link Archer MR200 v1 static routes not working after power cycle

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TP-Link Archer MR200 v1 static routes not working after power cycle

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TP-Link Archer MR200 v1 static routes not working after power cycle
TP-Link Archer MR200 v1 static routes not working after power cycle
2017-01-08 15:13:25
Model :

Hardware Version :

Firmware Version :

ISP :

Firmware Version: 0.9.1 1.1 v004a.0 Build 160905 Rel.60037n (which I got from http://uk.tp-link.com/download/Archer-MR200.html#Firmware)
Hardware Version: Archer MR200 v1 00000000

Hi,

My only problem with the Archer MR200 so far is that the static routes to my other router's subnet isn't working after the MR200 was power cycled.
The static route entry still exists, but its not working, and when I toggle the lightbulb in the Enable column it fails to enable it. When I then go and edit the whole row it works again.

Under the "Advanced Routing" I have the LTE interface selected as the "WAN Interface".
I then added a single static route:
Destination IP: 192.168.60.0

Subnet Mask: 255.255.255.0

Gateway: 10.0.0.3

Interface: LAN

Enable this entry: Checked


Then under "LAN Settings" I have it configured as:
IP Address: 10.0.0.2

Subnet Mask: 255.255.255.0

Second IP: Unchecked

DHCP: Unchecked


Should I rather send this to the TP-Link Technical Support instead?

Aside from this issue, I also find it strange that the available firmware on my country's webpage is very old and different: http://www.tp-link.co.za/download/Archer-MR200.html#Firmware

Thank you in advance,
Chris
  0      
  0      
#1
Options
2 Reply
Re:TP-Link Archer MR200 v1 static routes not working after power cycle
2017-01-09 16:11:54
I think your MR200 should be a special version, so the firmware for your region is different with other regions.
As for static route issue, I hasn't tried static route so I have no idea.
  0  
  0  
#2
Options
Re:TP-Link Archer MR200 v1 static routes not working after power cycle
2017-01-15 12:42:17
Thank for the feedback Aaron1. I've contacted TP-Link support on this matter too.


The error that I'm getting when I'm trying to enable the static route again, by toggling that light bulb, is:

Error code:5108

Gateway must be on the same subnet with the device interface's IP address. Please input another one.
  0  
  0  
#3
Options