tpPLC not showing all adapters

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
tpPLC not showing all adapters
tpPLC not showing all adapters
2017-02-04 19:30:36
Model :

Hardware Version :

Firmware Version :

ISP :

I purchased two pairs of AV2000 (Version 1) TL-PA9020P. I downloaded the latest version of tpPLC and when run only shows three out of the four AV2000's connected?

The diagram shows two at the top and one below, which is connected to the other two. Why can I not see all four, all of which are working and all of which are successfully connected to the internet? One is connected to the router and the others to media players.
0
0
#1
Options
1 Reply
Re:tpPLC not showing all adapters
2017-02-06 18:43:20
Did you use proper procedure to make them all part of the same powerline network?
0
0
#2
Options