thank you very much :D

I'm getting a blank page for Network - LTE Dial up so can't change my profile.

Was this issue resolved?

It was working this morning but has now vanished.

Problem still not resolved

Have this same problem WiFi working fine Lan too but not connection with 3G/LTE

Any solution? please

yuu666 wrote

Have this same problem WiFi working fine Lan too but not connection with 3G/LTE

Any solution? please

Hi yuu666, the issue we were suffering with was blank pages. The function of the router was fine, 3G/4G was working just couldn't alter anything on the Dial-up tab.

Update: I spoke with Tech support for an hour and they sent me a new version of firmware to try. Following the installation of this, my router turned into a brick... I now have a TP Archer MR200 and couldn't be happier...

JRJakkals wrote

Problem still not resolved

Did you try a different web browser or a hard reset on the router?

did you solve this? i experience the same problem, think it might be because i flashed the v1 firmware when i actually have version 2. I`ve tried to upload different firmware with recovery method using tftp and it transfers the bin file but after router has rebooted nothing has changed and the old firmware version is the same.

No resolution to my issue as the router was bricked by the prototype firmware installation. Router swapped out by TP. New router MR200 working well.

Anyone have MR6400 V1 and V2 stripped firmware?

I have the same problem. I tried to TFTP just the router.bin via renaming to mr6400_tp_recovery.bin (of firmware 170330) and I could see the "new logo" backend ov V2. But there are the same White pages if I try to configure 4G Connection. And also updates with the web backend are not possible.

It's not possible to successfully install any full Firmware via TFTP. Uploading works fine but after rebooting nothing happened. Still the same blank page issues.

Is there any support from TP Link or should I throw the device in the waste? Is it bricked now? Redirection to firmware upgrade page in Switzerland is a trap!!! ( http://www.tp-link.com/at/download/TL-MR6400.html) There's just a v1 upgrade and no option to select v2 so I thought I'm downloading the right Version. That really really sucks!