Archer MR200 Port Forwarding
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer MR200 Port Forwarding
Model :
Hardware Version :
Firmware Version :
ISP :
Hello
After setting up port forwarding rules (virtual server) I am able to use the services on the network, however, the same DDNS address used on the LAN won't resolve, does this router support NAT loopback / reflect? If it does, how do I enable it as I have scanned through every page and have not found it, if it doesn't, will it be supported at a later stage and when might that be? This is a rather important feature for me.
Hardware Version :
Firmware Version :
ISP :
Hello
After setting up port forwarding rules (virtual server) I am able to use the services on the network, however, the same DDNS address used on the LAN won't resolve, does this router support NAT loopback / reflect? If it does, how do I enable it as I have scanned through every page and have not found it, if it doesn't, will it be supported at a later stage and when might that be? This is a rather important feature for me.