TL-WR940N V5 only the On/Off LED is blinking
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-WR940N V5 only the On/Off LED is blinking
Model : TL-WR940N
Hardware Version :
Firmware Version :
ISP :
Good morning everyone.Yesterday I got my TL-WR940N V5.
After booting up the first time everything went fine.W-lan, lan and Internet works great.
Later on I changed the ssid and the w-lan password.
So far so good.
I switched off the router and placed him on his workplace.
After plugging in the power the router try to boot.
And there we are. Only the power LED is slowly blinking. Nothing else.
No lan LED or Internet is lighten up.
The wireless devices got an ip. But it's not possible to connect to the Web interface of the router. Even a ping is not possible.
So I tryed a hard reset. I gently sticked a toothpick in the reset hole. You can feel if it's pressed ;)
After 8 seconds all LED's should flash. Nothing.
So I tryed pressing it up to 1 minute. Nothing.
I tryed it with the wps button and the reset button.
I tryed the 30 30 30 reset.
Nothing helped.
The on/off LED is always blinking in the same time frequenz.
I can't connect via telnet ftp etc.
I havent updated the routers software.
I don't know the software version that's preinstalled.
Are there any other steps I can do? Or is the router dead?
thx Ardragoon
Hardware Version :
Firmware Version :
ISP :
Good morning everyone.Yesterday I got my TL-WR940N V5.
After booting up the first time everything went fine.W-lan, lan and Internet works great.
Later on I changed the ssid and the w-lan password.
So far so good.
I switched off the router and placed him on his workplace.
After plugging in the power the router try to boot.
And there we are. Only the power LED is slowly blinking. Nothing else.
No lan LED or Internet is lighten up.
The wireless devices got an ip. But it's not possible to connect to the Web interface of the router. Even a ping is not possible.
So I tryed a hard reset. I gently sticked a toothpick in the reset hole. You can feel if it's pressed ;)
After 8 seconds all LED's should flash. Nothing.
So I tryed pressing it up to 1 minute. Nothing.
I tryed it with the wps button and the reset button.
I tryed the 30 30 30 reset.
Nothing helped.
The on/off LED is always blinking in the same time frequenz.
I can't connect via telnet ftp etc.
I havent updated the routers software.
I don't know the software version that's preinstalled.
Are there any other steps I can do? Or is the router dead?
thx Ardragoon
File:
