Update Problems TL-PA8010P
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Update Problems TL-PA8010P
Model :
Hardware Version :
Firmware Version :
ISP :
Good day to you all.
I have tried to update the firmware on my Powerline TL-PA8010P v2 adapters but all i keep getting is 'Update Failed' error. Ive removed them from the network so that thy are not connected to each other or the internet, i run TP PLC program click on the found powerlink adapter, advanced settings, then the update tab, it then asks for the NVM and PIB. It shows the progress line it gets about 1/3 over and throws up the error. Tried restarting the computer unplugging and reconnecting the powerlink adapter, but to no avail?
Any advice would be very much appreciated.
Regards,
Paul
Hardware Version :
Firmware Version :
ISP :
Good day to you all.
I have tried to update the firmware on my Powerline TL-PA8010P v2 adapters but all i keep getting is 'Update Failed' error. Ive removed them from the network so that thy are not connected to each other or the internet, i run TP PLC program click on the found powerlink adapter, advanced settings, then the update tab, it then asks for the NVM and PIB. It shows the progress line it gets about 1/3 over and throws up the error. Tried restarting the computer unplugging and reconnecting the powerlink adapter, but to no avail?
Any advice would be very much appreciated.
Regards,
Paul
