Low Throughput - TL-PA8010P v3

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Low Throughput - TL-PA8010P v3

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Graham07

2021-12-30 10:59:27 - last edited 2022-01-06 10:26:47

Posts: 2

Helpful: 2

Solutions: 1

Stories: 0

Registered: 2021-12-30

Low Throughput - TL-PA8010P v3

2021-12-30 10:59:27 - last edited 2022-01-06 10:26:47

Model: TL-PA8010P KIT

Hardware Version: V3

Firmware Version: 200717

I know that I won't see anywhere near the throughput that the TP-Link utility shows; but it's showing a rate of 300-400Mbps between a pair of brand new adapters yet using speedtest.net and fast.com I'm only seeing 20-25 Mbps. So less that 10%. I was expecting enough to fully utilize my 45Mbps broadband connection.

A direct wired connection to my router is fine.

Any suggestions?

1 Accepted Solution

Graham07

LV1

2022-01-01 13:09:13 - last edited 2022-01-06 10:26:47

Posts: 2

Helpful: 2

Solutions: 1

Stories: 0

Registered: 2021-12-30

Re:Low Throughput - TL-PA8010P v3-Solution

2022-01-01 13:09:13 - last edited 2022-01-06 10:26:47

Well I had a broadband outage yesterday, not a great day.

However, through all the resets of the router and fixing the problem with the fibre in the area also seems to have resolved my low throughput on the powerline adapters, go figure.