Archer Vr2800 Dropping Max Line Sync Download & Upload & Not Getting Full Line Sync Speed
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hardware Version :
Firmware Version :
ISP :
Hi All,
Just wondering if anyone else is having this issue with this modem / router VR2800.
When you connect to the nbn vdsl2 it has your max line speed and actual speed.
Once connected the max line speed starts to drop below the connected speed , thus if i was to reconnect or the line dropped out i would then have a slower speed.
Also this modem does not sync the the max speed possible compared to other modem routers i have used.
I think the line sync issue needs to be fixed with a new firmware , unless anyone else has any other ideas.
I Have Tried Different Annex Combos , SRA On , Dt Line on Ect With No Improvement.
If Anything SRA AND DT Make the line speed decrease.
Any Help would Be Fantastic.
Good day.
Thank you for your time and patience.
May I know the hardware and firmware version about the Archer VR2800?
Where are you located and who is your internet service provider?
Could you please help me check the upload and download speed on the modem, maybe a picture of the DSL status page would be highly appreciated;
Later we would like to forward your case via email and please have a check of your message box.
Thank you very much and have a nice day.
Good day.
Thank you for your time and patience.
May I know the hardware and firmware version about the Archer VR2800?
Where are you located and who is your internet service provider?
Could you please help me check the upload and download speed on the modem, maybe a picture of the DSL status page would be highly appreciated;
Later we would like to forward your case via email and please have a check of your message box.
Thank you very much and have a nice day.