mr200 with external 3G/4G antennas
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
mr200 with external 3G/4G antennas
Model :
Hardware Version :
Firmware Version :
ISP :
I have a new archer mr200 where i would like to use an external antenna, or two, in order to improve 3g/4g reception.I have used my old galaxy s2 to confirm my 11dbi yagi antenna works and improves the signal from -90dbi to -70dbi. However when i unplug the little supplied antennas and plug in my external antenna the mr200 will not connect and reports no signal. I have tried both left and right side antenna ports.1) does the mr200 work with only 1 antenna like other leading brands?2) if so, which port is the primary port for single antenna?3) does this device allow you to choose a frequency to operate on. Eg: eg 900mhz or 4g 1800mhz?Thank you
Hardware Version :
Firmware Version :
ISP :
I have a new archer mr200 where i would like to use an external antenna, or two, in order to improve 3g/4g reception.I have used my old galaxy s2 to confirm my 11dbi yagi antenna works and improves the signal from -90dbi to -70dbi. However when i unplug the little supplied antennas and plug in my external antenna the mr200 will not connect and reports no signal. I have tried both left and right side antenna ports.1) does the mr200 work with only 1 antenna like other leading brands?2) if so, which port is the primary port for single antenna?3) does this device allow you to choose a frequency to operate on. Eg: eg 900mhz or 4g 1800mhz?Thank you
