Archer D7 virtual server fails, requiring a reset (port forwarding)
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer D7 virtual server fails, requiring a reset (port forwarding)
Model : Archer C7
Hardware Version :
Firmware Version : Firmware Version:1.9.0 0.9.1 v0051.0 Build 180705
ISP :
I have an SSH virtual server set up on my Archer D7. It forwards port 22 requests through to a statically assigned server on my LAN.
I have a noip domain set up to access my server remotely.
It works well, but after some use (often less than a day), I can no longer connect through the virtual server port forwarding. The router works fine in other respects and I can connect to the SSH server successfully if I connect internally (i.e. not through the virtual server).
This can be rectified by disabling and re-enabling the virtual server (by clicking on the lightbulb in the status column twice).
This is ok if I'm onsite, as I'm able to visit the router's configuration webpage. But if I'm remote - which is the primary use case - I can't do this.
Can this be fixed?
Hardware Version :
Firmware Version : Firmware Version:1.9.0 0.9.1 v0051.0 Build 180705
ISP :
I have an SSH virtual server set up on my Archer D7. It forwards port 22 requests through to a statically assigned server on my LAN.
I have a noip domain set up to access my server remotely.
It works well, but after some use (often less than a day), I can no longer connect through the virtual server port forwarding. The router works fine in other respects and I can connect to the SSH server successfully if I connect internally (i.e. not through the virtual server).
This can be rectified by disabling and re-enabling the virtual server (by clicking on the lightbulb in the status column twice).
This is ok if I'm onsite, as I'm able to visit the router's configuration webpage. But if I'm remote - which is the primary use case - I can't do this.
Can this be fixed?
