Archer MR200 disable IPv6

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer MR200 disable IPv6

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer MR200 disable IPv6
Archer MR200 disable IPv6
2019-10-09 20:21:12 - last edited 2019-10-10 02:57:07
Model: Archer MR200  
Hardware Version:
Firmware Version: 1.9.0 0.9.1 v0001.0 Build 190307 Rel.54196n

Hi,

 

How can I disable IPv6, I am not comfortable leaving this open even if I secure down connectivity via MAC address,  

 

Also a dumb question ho do I change trhe WAN interface name from LTE? Must have missed something.

 

Thanks in eager anticipation.

 

 

Steve

  0      
  0      
#1
Options
2 Reply
Re:Archer MR200 disable IPv6
2019-10-10 03:05:12

@nmitsteve 

 

Hello, the Archer MR200 supports IPV6 tunnel only and it is disabled by default. You can find it under advanced-network-IPV6 tunnel page/ 

 

The WAN interface time cannot be customized, it is negotiated according to the network type automatically. 

 

Good day. 

 

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  1  
  1  
#2
Options
Re:Archer MR200 disable IPv6
2019-10-11 09:04:55

Hi,

 

So today I noticed some IP v6 config on my LAN settings which I had not setup, my provider is 3 any reason for this?

 

MAC Address: D8:0D:17:22:XX:XX

IP Address: 0:0:0:0:da0d:17ff:feXX:XXXX
Prefix Length: 64
Assigned Type: Delegated

nmitsteve wrote

Hi,

 

How can I disable IPv6, I am not comfortable leaving this open even if I secure down connectivity via MAC address,  

 

Also a dumb question ho do I change trhe WAN interface name from LTE? Must have missed something.

 

Thanks in eager anticipation.

 

 

Steve

 

 
Shows i nadvanced . network ipv6 on the LAN
 
IPV6 tunnel does not show as enabled
 
All my DHCP is on a 10.11.X.X address
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 3078

Replies: 2

Related Articles