TD-W8960N configuration for specific functions

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TD-W8960N configuration for specific functions

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TD-W8960N configuration for specific functions
TD-W8960N configuration for specific functions
2019-12-05 23:32:59 - last edited 2019-12-06 06:55:55
Model: TD-W8961N  
Hardware Version:
Firmware Version:

Hi all, please help...
Consider the schema attached here below, is there someone can help on how to configure the router TD-W8960N so to have a working session from voip funcion on router3 to internet (provided by the 4G router)?
Many thanks for your support.

  0      
  0      
#1
Options
3 Reply
Re:TD-W8960N configuration for specific functions
2019-12-06 06:55:15 - last edited 2019-12-06 06:55:55

@Salvo_C 

 

So the TD-W8960N works as a wifi repeater to boost wifi signal from router 1 to router 2? 

 

If you just want TD-W8960N to provide internet for router 2, you can configure it as an access point or repeater. 

https://www.tp-link.com/support/faq/417/ 

https://www.tp-link.com/support/faq/264/

 

For the VOIP function on router 3, I'm afraid that it has nothing to do with the TD-W8960N. 

 

Good day. 

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options
Re:TD-W8960N configuration for specific functions
2019-12-06 09:13:38

Thanks Kevin, 
what I really need is to have  any device attached to Router3 working with Internet service provided by the Router1. The TD-W8960N should helpwith this.
This is a required configuration to have a backup internet connection whenever the VDSL line of the router3 will fall down... and also to verify if I can dismiss the fixed line in the next future.
 

  0  
  0  
#3
Options
Re:TD-W8960N configuration for specific functions
2019-12-06 09:23:25

@Kevin_Z 
(see also my previous answer)

Of course I cannot use any ethernet cable to connect R1 to R2 and also I am quite sure that R1 is not supporting the WDS option.

Thanks again.
Bye.

  0  
  0  
#4
Options

Information

Helpful: 0

Views: 1062

Replies: 3

Related Articles