Power goes on, blinks a bit then goes off

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Power goes on, blinks a bit then goes off

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Power goes on, blinks a bit then goes off
Power goes on, blinks a bit then goes off
2020-02-13 22:49:25 - last edited 2020-02-14 06:47:36
Model: TL-MR6400  
Hardware Version: V3
Firmware Version:

So this has worked ok for over a year. Today it just stops. I switched it off and back on, the power comes on then power light starts blinking. After a minute or so this light goes out and it sits there like a brick, no lights at all, no connection.

 

Is it new router time avoiding tp-link?

  14      
  14      
#1
Options
1 Reply
Re:Power goes on, blinks a bit then goes off
2020-02-14 06:46:20 - last edited 2020-02-14 06:47:36

@Bobafeta 

 

Hello, was there any firmware upgrade or power outage before this issue?

 

Try to hard reset it by holding the reset button/hole for 10s with the router powered on.

 

Besides, what is the hardware version of the router? You can find it on the back label, next to the model number. And when did you buy this router?

 

Good day.

 

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  3  
  3  
#2
Options

Information

Helpful: 14

Views: 15022

Replies: 1

Related Articles