IPSEC VPN tunnel - Single IP for local and remote tunnel access

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

IPSEC VPN tunnel - Single IP for local and remote tunnel access

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
IPSEC VPN tunnel - Single IP for local and remote tunnel access
IPSEC VPN tunnel - Single IP for local and remote tunnel access
2020-02-26 03:21:23 - last edited 2020-03-02 05:41:50
Model: Archer MR200  
Hardware Version: V2
Firmware Version: 1.0.0 0.9.1 v004a.0 Build 170516 Rel.37038n

Hello there,

 

On setting up IPSEC VPN section. I noticed there are option to set up tunnel access from local and remote access using single IP address instead using Subnet addresss. If both set to Single Address for both side for tunnel access. Will it work? In what scenario we can apply this?

 

Thank you very much

 

Alex

 

 

Alex Kota Kinabalu, Sabah Malaysia
  0      
  0      
#1
Options