Home Network Community > All Threads > Slave will not connect.
< All Threads

Slave will not connect.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Slave will not connect.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Slave will not connect.
Slave will not connect.
2020-03-22 16:51:02
Model: Deco M4  
Hardware Version: V2
Firmware Version:

When I try to connect my slave is the led red and not blue. 
what Can I do?

  0      
 
  0      
 
#1
Options
1 Reply
Re:Slave will not connect.
2020-03-23 06:37:32

@Jonas123 

 

With the slave Deco powered on, hold on the reset hole for 1s. Then you can set it up via the Deco app. 

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 620

Replies: 1

Related Articles
Slave router doesn’t connect to internet
4319 2
Maiking a Slave Deco the Main Deco - Why?
1764 0
slave Deco M4R does not connect via cable but only via wifi
344 1
Deco slave is unstable
613 0
Deco top floor slave not using middle floor slave
462 0
Master/slave DECO M4
2121 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.