Hello,

I have bought a Deco M4 3-pack and installed it in AP mode. The results were great and I was very happy with the network speed improvement.

But then, 3 days later, I had to disconnect my main Deco M4 because of some cable layout changes. After the changes were done, I turned the modem and the router off, and then reconnected both the router and the main Deco. At first everything was looking fine, but then I decided to test the network speed close to my satellite Decos and the results were extremely low. I had to wait another 2 days for the speeds to return back to how they were before. The only diference I spotted was that there was no IPv6 address attributed to the network while the speeds were low. However, I don't know if it has anything to do with it...

In case there is an eletricity fault, or if I need to turn the main deco off, will I have to wait another 2 days for the speeds to go back to normal or is there any way of speeding up the process? I'm quite concerned about this...

Please, please, help!