ER4 Deco AC1200

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ER4 Deco AC1200

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
ER4 Deco AC1200
ER4 Deco AC1200
2020-08-23 17:18:57 - last edited 2020-08-24 11:52:48
Model: AC500  
Hardware Version:
Firmware Version: 1.4.2 Build 20200727 Rel. 49069

Just had 900mb BT internet FTTP installed, yet I cannot get my Deco's to run above 90Mbps at all. I am using it in access point mode. Are these not 1gbps compatible, if not can anyone advise which models to upgrade to?

  0      
  0      
#1
Options
1 Accepted Solution
Re:ER4 Deco AC1200-Solution
2020-08-24 11:32:19 - last edited 2020-08-24 11:52:48

The E4 only has 100mbit ethernet ports, so that's where your bottleneck is. You can get a single unit of M4 or M5 and higher which have gigabit ethernet and use it as your main Deco so you can get gigabit speeds on your entire Deco mesh network even on the E4 nodes.

Recommended Solution
  1  
  1  
#2
Options
2 Reply
Re:ER4 Deco AC1200-Solution
2020-08-24 11:32:19 - last edited 2020-08-24 11:52:48

The E4 only has 100mbit ethernet ports, so that's where your bottleneck is. You can get a single unit of M4 or M5 and higher which have gigabit ethernet and use it as your main Deco so you can get gigabit speeds on your entire Deco mesh network even on the E4 nodes.

Recommended Solution
  1  
  1  
#2
Options
Re:ER4 Deco AC1200
2020-08-24 11:53:16
Thanks for the reply Neilrg, really appreciated. Cheers!
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 597

Replies: 2

Related Articles