Interface problem
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Dear Sir/Madam
Hello i'm sujit pandit. Before few a days i'm using this model it's good now i'm facing problem. The problem are
< At the interfacing with lan port.
< VLAN ID not there then also showing this
i changed firmwere then also i faced same problem. Below picture is here what i was phased the peoblem.
Thank you.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Good day.
Sorry for the delay.
Just want to be sure, even after reset, and choose the wireless router mode again, the same error message would still be here, right?
Is the router given by your internet service provider?
And is the first that you set up the MR200 as a wireless router with the fiber connection?
Later, we would like to follow up your case via email and please have a check of your email box.
Thank you very much.
- Copy Link
- Report Inappropriate Content
Good day.
Have you changed the operating mode to wireless router mode, instead of 3/4G router mode?
And if you reset the Archer MR200 and set it up again , would you have the same issue?
Thank you very much.
- Copy Link
- Report Inappropriate Content
yes i changed router mode. then also same problem. if i select 3G/4G it's ok but i have fiber connection so i changed as router mode.
- Copy Link
- Report Inappropriate Content
Good day.
Sorry for the delay.
Just want to be sure, even after reset, and choose the wireless router mode again, the same error message would still be here, right?
Is the router given by your internet service provider?
And is the first that you set up the MR200 as a wireless router with the fiber connection?
Later, we would like to follow up your case via email and please have a check of your email box.
Thank you very much.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 584
Replies: 3
Voters 0
No one has voted for it yet.