Cannot connect to Archer C6 after firmware update
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello, today I did firmware update from my Tether app (on iPhone), where I was connected to my router properly. After update, I can't connect to my router from Tether - it says wrong password. However, when I try to connect by tp link web, it connects me just fine. Is there any chance where I could try to change password without reseting my settings?
Thank you for your answer and sorry for my bad english, it is not my first language.
Best regards, Vlastimil
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello,
Please check the following info if Tether failed to log in TP-Link device:
1. Make sure it is the correct login username/password (admin/admin in default settings and this might be changed by yourself; if the TP-Link device is bound to a TP-Link ID, please check it as well). The username/password is the same as your login credentials for the web management page.
2. Make sure the TP-Link device is using the latest firmware.
3. Ensure it is in Router or Access Point mode.
4. Reboot the TP-Link device or restart the Tether app.
5. If the username/password is forgotten, please reset the device manually and use the default login credentials (admin/admin).
May it help.
- Copy Link
- Report Inappropriate Content
Hello,
Please check the following info if Tether failed to log in TP-Link device:
1. Make sure it is the correct login username/password (admin/admin in default settings and this might be changed by yourself; if the TP-Link device is bound to a TP-Link ID, please check it as well). The username/password is the same as your login credentials for the web management page.
2. Make sure the TP-Link device is using the latest firmware.
3. Ensure it is in Router or Access Point mode.
4. Reboot the TP-Link device or restart the Tether app.
5. If the username/password is forgotten, please reset the device manually and use the default login credentials (admin/admin).
May it help.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1381
Replies: 1
Voters 0
No one has voted for it yet.