Link aggregation of two ports to double the speed on C2300

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

2020-09-03 02:45:23 - last edited 2020-09-03 06:24:54

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-09-03

Link aggregation of two ports to double the speed on C2300

2020-09-03 02:45:23 - last edited 2020-09-03 06:24:54

Model: Archer C2300

Hardware Version:

Firmware Version:

how can I do link aggregation of two ports to double the speed, that is how two output cables can become one input cable?

thank you for any help

1 Accepted Solution

2020-09-03 06:24:35 - last edited 2020-09-03 06:24:54

Posts: 21780

Helpful: 5149

Solutions: 2575

Stories: 21

Registered: 2018-12-24

Re:Link aggregation of two ports to double the speed on C2300-Solution

2020-09-03 06:24:35 - last edited 2020-09-03 06:24:54

Hi, you may refer to the below guidance to configure the link aggregation on the router:

May it help.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

Helpful: 0

Replies: 1