Command Line help
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Command Line help
Region : UnitedKingdom
Model : TD-W8951ND
Hardware Version : V4
Firmware Version : 2.12.58.12(E03.AZ.3)3.12.8.31 20120228_v004
ISP :
Good afternoon,
I'm having quite a unique problem with my TP-Link router.
I have locked myself out of the GUI...... I accidentally did this from the Access Management ACL page
Thankfully i can access the router via telnet (told you it was unique).
What i need to be able to do is to either add in an access-rule or edit the current access rules via the command line.
I have looked around online and not appeared to have found much in regards to the TP-Link CLI.
Is it possible to add ACL rules or even disable it temporarily via the CLI?
Any help is appreciated
Lewis
Model : TD-W8951ND
Hardware Version : V4
Firmware Version : 2.12.58.12(E03.AZ.3)3.12.8.31 20120228_v004
ISP :
Good afternoon,
I'm having quite a unique problem with my TP-Link router.
I have locked myself out of the GUI...... I accidentally did this from the Access Management ACL page
Thankfully i can access the router via telnet (told you it was unique).
What i need to be able to do is to either add in an access-rule or edit the current access rules via the command line.
I have looked around online and not appeared to have found much in regards to the TP-Link CLI.
Is it possible to add ACL rules or even disable it temporarily via the CLI?
Any help is appreciated
Lewis
