AC1900 in Wireless Access Point Mode Dropping Internet Connection to Router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

AC1900 in Wireless Access Point Mode Dropping Internet Connection to Router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
AC1900 in Wireless Access Point Mode Dropping Internet Connection to Router
AC1900 in Wireless Access Point Mode Dropping Internet Connection to Router
2020-12-02 19:39:34 - last edited 2020-12-03 14:08:32
Model: Archer A9  
Hardware Version: V6
Firmware Version:

I have just set up a new AC1900 A9 in Wireless Access Point mode:

 

  1. It is updated with the latest firmware
  2. It is configured specifically as a Wireless Access Point during setup using Smart IP-DHCP for connection to the router
  3. It is plugged into the LAN port on a Hitron Modem/Router via the WAN port on the AC1900 as instructed in set up
  4. It is set up near the Hitron; the Hitron is not bridged and is still an active Wifi/LAN router

 

The problem:

 

After setting up the above configuration, testing and using the AC1900 it performs as expectded for about 18 - 20 hrs. Then the internet connection on the AC1900 drops (internet light goes to yellow) and internet wifi is not useable. I have to reboot the Hitron in order to restore an internet connection to the AC1900. Rebooting the AC1900 only does not fix the problem.

 

I say 18 - 20 hrs. as the connection drops sometime overnight after rebooting in the morning. It has happened twice in a row over the first two nights of using the unit.

 

More concerning is that it also takes down the wifi internet connectivity of the Hitron and any devices connected by wifi to the Hitron can't get internet. So all internet wifi connectivity is lost to all devices, not just those connected to the AC1900.

 

The internet from my ISP is still active as the wired LAN connection is unaffected and I can still get internet on my computer that is hard wired to the Hitron.

 

I have tried to troubleshoot cables, software settings, router configurations but nothing is obvious at this point. I have had to take the AC1900 offline otherwise all wifi internet is lost to every device every morning.

 

Any suggestions would be appreciated as I can't seem to find the cause or solution to this issue so far.

 

 

 

 

 

  0      
  0      
#1
Options
1 Accepted Solution
Re:AC1900 in Wireless Access Point Mode Dropping Internet Connection to Router -Solution
2020-12-03 06:01:10 - last edited 2020-12-03 14:08:32

@JJG 

 

Hi, please ensure the DHCP on the A9 is disabled, then try to disable the Smart DHCP on the A9, change it to a static one, which is in the same subnet as the Hitron. For example, if the gateway of the Hitron is 192.168.1.1, change the LAN IP address of the A9 to 192.168.1.2, then confirm.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
Recommended Solution
  0  
  0  
#2
Options
3 Reply
Re:AC1900 in Wireless Access Point Mode Dropping Internet Connection to Router -Solution
2020-12-03 06:01:10 - last edited 2020-12-03 14:08:32

@JJG 

 

Hi, please ensure the DHCP on the A9 is disabled, then try to disable the Smart DHCP on the A9, change it to a static one, which is in the same subnet as the Hitron. For example, if the gateway of the Hitron is 192.168.1.1, change the LAN IP address of the A9 to 192.168.1.2, then confirm.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
Recommended Solution
  0  
  0  
#2
Options
Re:AC1900 in Wireless Access Point Mode Dropping Internet Connection to Router
2020-12-03 14:07:06

@Kevin_Z 

 

Thanks for the tip. That is what I did last night, as well as reserving the static IP on my modem/router as one extra step.

 

Everything is running fine now and the problem is resolved.

 

 

 

  0  
  0  
#3
Options
Re:AC1900 in Wireless Access Point Mode Dropping Internet Connection to Router
2020-12-04 00:48:32

@JJG 

 

Hi, glad to know it works.

 

Just let us know if you have any other inquiries.

 

Good day~

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 1375

Replies: 3

Related Articles