Reset router now not usable
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Reset router now not usable
I rest my router via the small hole in the side now it seems to be in some sort of reset loop. I can see the default wifi network but am unable to connect to it. Through an ethernet cable I can see packets being sent to it but nothing in return. I've tried resetting multiple times but it has the same behaviour
Re:Reset router now not usable
How about the LEDs on the front of the VR600 after the reset? Are they properly on as per the User manual? When you connect the computer to the VR600 with an Ethernet cable, does it get a valid IP address like 192.168.1.100? Are you able to access its web interface?
Try one more time to reset the device by holding the RESET button for more than 10s, when you do the hard reset, please check and ensure the PWR LED go off then on.
Nice to Meet You in Our TP-Link Community.
Check Out the Latest Posts:
Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN
Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router
Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection
Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul
If you found a post or response helpful, please click Helpful (arrow pointing upward icon).
If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.