Home Network Community > All Threads > My TL-PA8015P KIT is stuck in power saving mode
< All Threads

My TL-PA8015P KIT is stuck in power saving mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

My TL-PA8015P KIT is stuck in power saving mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
My TL-PA8015P KIT is stuck in power saving mode
My TL-PA8015P KIT is stuck in power saving mode
2021-02-20 14:08:34
Model: Adapter  
Hardware Version: V2
Firmware Version:

Hello,

 

I have a TL-PA8015P KIT. One of them is working normally, but the other one is unable to quit the power saving mode.

It is not recognized by tpCPL.

I tried to pair again the two adapters (1 second press) : fail
I tried to reset the faulty CPL (6 seconds press) : no effect, the LED is always blinking slowly

So I have no network.

 

Thanks in advance for your help

 

Best regards

  0      
 
  0      
 
#1
Options
1 Reply
Re:My TL-PA8015P KIT is stuck in power saving mode
2021-02-23 09:49:11

@Westman49 For a full factory reset, you'll probably need to hold the button for way longer than six seconds. Just hold it until you see a reaction on the LEDs.

 

I'd give up after a minute though; next thing to try would then be recovery over LAN.

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 735

Replies: 1

Related Articles
TL-PA8010P Kit Power-saving Mode not working?
1080 0
TL-PA8010PKIT - any way to turn off Power Saving Mode?
3021 0
Pa8015p kit
212 0
Power saving mode
501 0
PA9020KIT wont enter power saving mode
1004 0
Adding Wifi to a TL-PA8015P KIT
787 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.