Help needed . Which mode do I need on TL-WA901ND ?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Help needed . Which mode do I need on TL-WA901ND ?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Help needed . Which mode do I need on TL-WA901ND ?
Help needed . Which mode do I need on TL-WA901ND ?
2021-04-03 15:50:48 - last edited 2021-04-06 11:11:14
Model: TL-WA901ND  
Hardware Version: V5
Firmware Version: 160929

Hello.  I have a silly question but my boyfriend who normally deals with this is in hospital.

 

i have a TP-link MR600 4g router which cannot get a wifi signal to all of the house, so I want to connect a TLWA901ND device via Ethernet cable to broadcast the same wifi network to the rooms the main Router cannot reach.  I do not want a separate network as I have several smart devices that need to be on the same SSID .

 

My question is which mode does the TL-WA901ND need to be configured?  I know it's not "multiple SSID" but am confused as to which of the other operation modes I need?  : Access Point, Repeater, Bridge with AP, Client ?

 

i cannot connect the router and access point wirelessly as the signal is not sufficient,, so an Ethernet cable is already in,place.

 

Please can someone advise me ?

 

Thanks, June.

  0      
  0      
#1
Options
1 Accepted Solution
Re:Help needed . Which mode do I need on TL-WA901ND ?-Solution
2021-04-05 22:01:26 - last edited 2021-04-06 11:11:14

@Junipoos 

 

Hey June

 

Hope you are well and welcome!

 

If you have it connected via a cable to the MR200, then choose    ACCESS POINT mode

 

Once that is done set the WiFi name (SSID) and password the same as your MR200, this should then work for you

 

 

Recommended Solution
  1  
  1  
#2
Options
3 Reply
Re:Help needed . Which mode do I need on TL-WA901ND ?-Solution
2021-04-05 22:01:26 - last edited 2021-04-06 11:11:14

@Junipoos 

 

Hey June

 

Hope you are well and welcome!

 

If you have it connected via a cable to the MR200, then choose    ACCESS POINT mode

 

Once that is done set the WiFi name (SSID) and password the same as your MR200, this should then work for you

 

 

Recommended Solution
  1  
  1  
#2
Options
Re:Help needed . Which mode do I need on TL-WA901ND ?
2021-04-05 22:08:54

@Philbert 

 

Thank you so much!

  2  
  2  
#3
Options
Re:Help needed . Which mode do I need on TL-WA901ND ?
2021-04-05 22:09:36
Most Welcome!
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 901

Replies: 3

Related Articles