TPLink Archer c6 v2 QoS not showing Downlink speed
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
The router's software isn't showing the downlink speeds for any devices connected to it. It only shows the uplink speeds and it only measures upload data consumption. Download consumption is not measured.
So is it a problem with the firmware or the router, or have I done the setup incorrectly.
Wan cable is connected to a Cable modem (gateway) on which DHCP and NAT is disabled.
So PPPOE is on the router and ISP's IP address is assigned directly to the router:: I don't think that this is the problem but I have done this by my self so let me know if the above is the culprit
I personally think that this is a firmware issue and can be fixed by TPLink
In the attached screenshot, Clients: PI-SERVER is doing heavy downloading (that is at 15 MB/s [Megabytes/sec]) and FEIN5L0032 is on a zoom call, still you can see that it isn't displaying downlink speeds
Its the same case with the webapp
@Kevin_Z No sir, not even on WebGUI. It only shows the upload speed and counts the upload data usage. It doesn't display download speeds and doesn't count download usage. Here are the screenshots
In the first screenshot, you can see that this device (prioritized one) is doing an upload test, and also it is being correctly displayed on the GUI 2.8 MB/s ~ 22.4 mbps ; pretty accurate
In the second screenshot, you can see that this device (prioritized one) is doing a download test, but nothing is displayed on the downlink
