[TPLINK WR90N v3] doesn't have option for range extender and WDS setup isn't working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
12

[TPLINK WR90N v3] doesn't have option for range extender and WDS setup isn't working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
11 Reply
Re:[TPLINK WR90N v3] doesn't have option for range extender and WDS setup isn't working
2021-07-25 13:24:49

@Aveon 

 

It's not mandatory as along as WR940N LAN IP address is in the same subnet.

In general WR940N LAN IP address should be outside C6 DHCP range, but in the same subnet (192.168.0.254 is fine).

Not connecting in WDS2 mode means that you should use WDS1, if Auto doesn't work for you.

If it's too complex to swap the devices and test, I would suggest you to use WR940N as an AP - Case2., connecting it to C6 with an ethernet cable (if possible, depending on your infrastructure).

Thus you would have more stable and faster connection between routers and your wireless devices. 

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#12
Options
Related Articles