OneMesh Not enabled On AX10 (AX1500)
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Recently purchased an AX10 (1500) to use OneMesh in my home. I chose this router as it was recomended as one of the OneMesh supported routers on the https://www.tp-link.com/onemesh/product-list/?app=tether page.
How do I enable OneMesh on this router.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@terziyski Thanks. Checked the firmware. I have updated the firmware and OneMesh is now working.
- Copy Link
- Report Inappropriate Content
@terziyski I've just bout an AX1500 because I was under the impression it supported OneMesh. It's on Firmware 1.2.5 Build 20220117 Rel. 51845(4555), and my BE605X's say OneMesh not supported on my wifi.
It's in Access Point mode because there's existing hardware I cannot replace for various reasons for the LAN. Is this what's stopping me? Or is there something else I'm missing?
- Copy Link
- Report Inappropriate Content
Yes, that's the culprit - see OneMesh FAQ - Q8/A8.
If you have an ISP device before your AX1500 which could be set in bridge (modem only) mode and configure AX1500 in router mode, you should be able to build a OneMesh between AX1500 and RE605X.
- Copy Link
- Report Inappropriate Content
I updated the router firmware to Version 1.2.5 Build 20220117 Release 52085 to allow the OneMesh to work.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1857
Replies: 5
Voters 0
No one has voted for it yet.