Tplink WA801ND Acces Point

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Tplink WA801ND Acces Point

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Tplink WA801ND Acces Point
Tplink WA801ND Acces Point
2021-08-04 12:47:57 - last edited 2022-12-29 09:59:46
Model: TL-WA801ND  
Hardware Version: V5
Firmware Version: 0.91.3.16

Hello , if  i choose multiple ssid mode.Could  i create a  ssid with limit Bandwitch ?What about Max Tx Rate? It is usefull to decrease this rate in order to have limit download and upload internet traffic?

 

 

Thanks

  0      
  0      
#1
Options
3 Reply
Re:Tplink WA801ND Acces Point
2021-08-04 15:26:01

@panosv 

 

Hey

 

The Multiple SSID mode is designed to work on different VLANs, mostly for business use.   Unless you have a router and switch which can support VLANs this wont be much use to you.

 

  0  
  0  
#2
Options
Re:Tplink WA801ND Acces Point
2021-08-05 07:33:18

@panosv Is it possible to create a (ssid = guest)vlan with limited bandwidth(download/upload)?

  0  
  0  
#3
Options
Re:Tplink WA801ND Acces Point
2021-08-05 08:27:03

@panosv 

 

It would depend on the hardware you have available to do this, VLANs require the AP, Switch and Router to support the VLAN.  This is generally not something that is possible with home grade hardware

 

Assuming that you have the hardware in place.

1. On your Switch and Router create a new VLAN, call it GUEST and set its ID for 123

2. Switch the WA801ND to MultiSSID mode and create a WiFi network called Guest, set the VLAN ID as 123.   Traffic now on that SSID will flow via the VLAN 123 and not near your "personal" traffic

3. Lastly on the switch you can enable can Bandwidth Controls for that VLAN, set it for 10mbps down, 1mbps up or whatever you feel appropriate.  This will indeed limit the bandwidth for you. 

 

I have 4x vlans at home and use bandwidth controls on all of them, again via the switch.   This is typically not something you want the AP doing

 

A quick hardware setup for this would be

1x OC200 Controller

1x TL-R605 Router

1x TL-SG2008P Switch

1x EAP225

 

That setup is based on Omada and would allow you to create as many VLANs as you wish, put bandwidth controls on them and even have a portal access for guests.

 

 

  0  
  0  
#4
Options

Information

Helpful: 0

Views: 882

Replies: 3

Related Articles