ARP list before rebooting and Hardware NAT
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
ARP list before rebooting and Hardware NAT
Region : Spain
Model : TL-WDR4900
Hardware Version : V1
Firmware Version : 3.14.7 Build 130424 Rel.72646n
ISP : Movistar
Good afternoon, I recently purchased a TP-Link Router WDR4900 and I have found that if I have activated the function "Hardware NAT" MAC addresses do not work reserved for ARP list.
That is, if I reserve a MAC address in "Binding Settings" by clicking the box "bind" and function "Hardware NAT" is enabled and restart the router, not reserved MAC addresses stored.
However, if the function "Hardware NAT" is disabled and reboot the router, the ARP table with the MAC addresses appears set manually.
I pray you take into consideration this problem in the next software update because the ARP table is essential to use "Wake On Lan" from outside the network and now I have to keep off "Hardware NAT".
The software version is 3.14.7 Build 130424 Rel.72646n.
Thank you.
Model : TL-WDR4900
Hardware Version : V1
Firmware Version : 3.14.7 Build 130424 Rel.72646n
ISP : Movistar
Good afternoon, I recently purchased a TP-Link Router WDR4900 and I have found that if I have activated the function "Hardware NAT" MAC addresses do not work reserved for ARP list.
That is, if I reserve a MAC address in "Binding Settings" by clicking the box "bind" and function "Hardware NAT" is enabled and restart the router, not reserved MAC addresses stored.
However, if the function "Hardware NAT" is disabled and reboot the router, the ARP table with the MAC addresses appears set manually.
I pray you take into consideration this problem in the next software update because the ARP table is essential to use "Wake On Lan" from outside the network and now I have to keep off "Hardware NAT".
The software version is 3.14.7 Build 130424 Rel.72646n.
Thank you.
