Home Network Community > All Threads > router not getting internet connection when configured using backup file
< All Threads

router not getting internet connection when configured using backup file

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

router not getting internet connection when configured using backup file

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
router not getting internet connection when configured using backup file
router not getting internet connection when configured using backup file
2022-05-07 09:39:17

i use an Archer C20 US V5 as my main router.

 

a day ago at night it lost internet connection. i found out it was my router that lost internet anonymously. i reset it, uploaded the backup file that i had saved and it configured the router but no internet was there. weirdly, the wired devices still got internet while the wireless devices showed 'no internet'.

i reset it again and logged in to my ISP's pppoe id and all was well. this time both the wireless and wired devices got internet connection successfully. 

 

i have the latest firmware installed too.

  0      
 
  0      
 
#1
Options
1 Reply
Re:router not getting internet connection when configured using backup file
2022-05-10 03:10:43

Hello @hamimrahman.17 

 

Is the WAN Connection Type PPPoE on the C20? Who is your ISP?

 

If there is no internet access when you upload the old configuration file into the router, but the internet works when you reconfigure it from scratch, I assume the settings saved on the router may no longer march the changes made by your ISP or modem. It's suggested to monitor the connectivity again and pay attention to the ISP modem connectivity as well.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 418

Replies: 1

Related Articles
Getting Invalid network Configuration
452 0
2Ghz & 5Ghz lights not getting turned on post configuration.
1231 0
Router is not getting internet from midem
324 1
router getting automatically off
429 0
Not getting internet connection in repeater mode
953 0
My internet connection getting dropped continuously
691 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.