TPLink Archer8 Configuration with Fastweb

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TPLink Archer8 Configuration with Fastweb

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TPLink Archer8 Configuration with Fastweb
TPLink Archer8 Configuration with Fastweb
2022-11-26 19:19:51
Tags: #fastweb
Model: Archer A8  
Hardware Version: V1
Firmware Version: 1.11.30 Build 220624 Rel.50807n(4555)
Good evening everyone. I have an internet contract with fastweb for which I requested a free modem (TP-Link). After numerous tinkering I finally managed to connect to the internet using the following VLAN settings. 
And also activating the NAT, since Fastweb from what I've read is a virtual network that goes out on the internet through the NAT.
At this point I've decided to apply for a public IP, since I have numerous smart home devices that I need to control from outside the house.
Fastweb assigned me a public IP, sent to me by SMS, but it seems that the router and my connection are not affected, even if I tried several times to setup the router.
Do you happen to know if any particular configuration needs to be done? Support gave me spades as if you request a free modem you lose your right to support.

  0      
  0      
#1
Options
1 Reply
Re:TPLink Archer8 Configuration with Fastweb
2022-12-02 05:55:48

@ClaudioMerli 

 

It seems Fastweb provides a CGNAT network, thus you get a private WAN IP address on the A8 router.

 

This cannot be changed on the 8 itself, it can only be changed by Fastweb.

If my reply helps with the issue, please click on the arrow pointing upward. If it solves your issue, please click the star to mark it as a "Recommended Solution".
  0  
  0  
#2
Options