Extender RE200 access point mode no more than 100MB

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Extender RE200 access point mode no more than 100MB

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Extender RE200 access point mode no more than 100MB
Extender RE200 access point mode no more than 100MB
2023-01-20 13:28:27 - last edited 2023-01-30 02:12:33
Model: RE200  
Hardware Version: V3
Firmware Version:
Hello

I have a RE 200 device in access point mode connected via ethernet cable directly to my modem.

In the input cable to the repeater I have 300Mbs but when I connect it to the repeater and configure it as an access point in both networks (2.4 and 5.8) I have 100MB, the same happens if I unify the networks.

 

 

  0      
  0      
#1
Options
1 Accepted Solution
Re:Extender RE200 access point mode no more than 100MB-Solution
2023-01-23 13:39:40 - last edited 2023-01-30 02:12:33

  @Zequiab 

 

That happens because RE200 ethernet port is only 100mbps capable and it creates a bottleneck for any device connected to its wireless radio - check RE200 specs here.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
Recommended Solution
  2  
  2  
#3
Options
2 Reply
Re:Extender RE200 access point mode no more than 100MB
2023-01-21 13:11:12
No conneted for theater
  0  
  0  
#2
Options
Re:Extender RE200 access point mode no more than 100MB-Solution
2023-01-23 13:39:40 - last edited 2023-01-30 02:12:33

  @Zequiab 

 

That happens because RE200 ethernet port is only 100mbps capable and it creates a bottleneck for any device connected to its wireless radio - check RE200 specs here.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
Recommended Solution
  2  
  2  
#3
Options