Remote Access Archer MR600
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have a Archer MR600 LTE router that i am trying to gain remote access to. i have enabled remote access in System tools Administration. It will not connect using the Public IP. I have searched the net for answers but there is no difinitive solution. Any help?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, is your MR600 working on 3G/4G Router mode? And is the Internet IPv4 address displayed on the Advanced->Status page a public IP address or not?
Please refer to the instruction below to troubleshoot the remote web management issue:
https://www.tp-link.com/en/support/faq/3364/
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi, thanks for the reply.
What is the hardware and firmware version of your MR600? Please check it on Advanced->System Tools->Firmware Upgrade page.
If it is already the latest firmware, please send an email to "support.forum@tp-link.com" and provide the screenshots of Status page, Remote Management page along with the Firmware Upgrade page, our engineer will follow up for further troubleshooting.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 3
Views: 1402
Replies: 3
Voters 1
