How do I set Deco to assign IP-addresses?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How do I set Deco to assign IP-addresses?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How do I set Deco to assign IP-addresses?
How do I set Deco to assign IP-addresses?
2023-04-07 15:17:42
Model: Deco M5  
Hardware Version:
Firmware Version: 1.6.5.

I have connected dahua NVR to my deco m5 with a enternetcable. But NVR is not being found. I kan se that other has had same problem. See this thread.  
"NVR not being detected by hub (network) when using ethernet cable".

The solution seems to be this:

 

Re:Re:NVR not being detected by hub (network) when using ethernet cable

Hi @Vesito , yes I got it working. For me, the solution was to let the Deco assign IP-addresses (act as a DNS server), and disable DNS in the NVR. Hope this works for you too. 


my question: How do I set Deco to assign IP-addresses? Or does anyone have other solutions?

  0      
  0      
#1
Options
1 Reply
Re:How do I set Deco to assign IP-addresses?
2023-04-09 06:29:28

@Atorm Did you do the second part? (disable dns in the NVR)

Just a M4 (2-pack) user who regrets buying it
  0  
  0  
#2
Options