error code: 4801 and bandwidth control rules applies to all users

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

error code: 4801 and bandwidth control rules applies to all users

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
error code: 4801 and bandwidth control rules applies to all users
error code: 4801 and bandwidth control rules applies to all users
2023-08-06 05:58:33
Model: TL-WR845N  
Hardware Version: V4
Firmware Version: V4_201214

  0      
  0      
#1
Options
2 Reply
Re:error code: 4801 and bandwidth control rules applies to all users
2023-08-06 06:05:04

I believe the "All" thing is the main cause of this issue, so I tried leaving the right side of the IP range blank, but it did not work. It would be quite helpful if some were to help me and thank you

  0  
  0  
#2
Options
Re:error code: 4801 and bandwidth control rules applies to all users
2023-08-07 02:05:56 - last edited 2023-08-07 02:07:13

  @Sai340 

 

I believe the problem is with your egress bandwidth minimum values that you're trying to set - try with bigger values.

There's a thread which describes this error message - here.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 860

Replies: 2

Related Articles