Tp-link

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Tp-link

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Tp-link
Tp-link
2024-01-04 21:15:24 - last edited 2024-01-08 01:19:39
Model: RE220  
Hardware Version: V3
Firmware Version: V3

Hi everyone my wifi extender isn't showing up when I go to wifi settings. I had it on my phone network and wanted to to change it to home network not even sure if it was working 100% because its been a while but I disconnected it from showing up on mu mobile and now can't even find it. There is a solid green light only 1

Any help with this please 🙏 

Thank you 

  0      
  0      
#1
Options
1 Accepted Solution
Re:Tp-link-Solution
2024-01-06 15:47:41 - last edited 2024-01-08 01:19:39

  @Bunker_Ram-87 

 

After a successful reset the Wi-Fi should be without password and when accessing the settings for the first time the user should be asked to enter and repeat a new password.

 

If you are still being asked for a previously set password, then the reset was not successful.

When you perform the reset press and hold the small button until you notice a distinctive response from the LED lights, like all LEDs turn on or off simultaneously.

 

Recommended Solution
  1  
  1  
#4
Options
3 Reply
Re:Tp-link
2024-01-05 18:39:10

  @Bunker_Ram-87 

 

Hi,

 

Press and hold the small "Reset" button for a couple of seconds and then setup the RE200 again. (refer to the official Quick Guide for setup instructions)

 

  0  
  0  
#2
Options
Re:Tp-link
2024-01-06 07:24:19

  @woozle hi there thks 4 your reply the reset button I've tryed this is finds a connection like a ext: but I don't remember the password and I've tryed to reset it with no luck

  0  
  0  
#3
Options
Re:Tp-link-Solution
2024-01-06 15:47:41 - last edited 2024-01-08 01:19:39

  @Bunker_Ram-87 

 

After a successful reset the Wi-Fi should be without password and when accessing the settings for the first time the user should be asked to enter and repeat a new password.

 

If you are still being asked for a previously set password, then the reset was not successful.

When you perform the reset press and hold the small button until you notice a distinctive response from the LED lights, like all LEDs turn on or off simultaneously.

 

Recommended Solution
  1  
  1  
#4
Options

Information

Helpful: 0

Views: 352

Replies: 3

Related Articles