Home Network Community > All Threads > Impossible to set-up in new Home office
< All Threads

Impossible to set-up in new Home office

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Impossible to set-up in new Home office

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Impossible to set-up in new Home office
Impossible to set-up in new Home office
2024-01-06 15:23:32 - last edited 2024-01-06 16:14:47
Model: Deco X50  
Hardware Version: V1
Firmware Version: last

Impossible to setup 

Previously worked perfectly in same network in previous home office

 

Here a real mess :

- blinking blue then steady blue then… red

- network is visible in Wifi settings but Deco doesn't connect because iPhone 14 Pro is indfinitely trying to connect, but Deco goes red after 20 seconds…

 - reboot modem + Deco 15 times

 

Infuriatingly lost 2 hours !!!

  0      
 
  0      
 
#1
Options
2 Reply
Re:Impossible to set-up in new Home office
2024-01-06 15:38:01 - last edited 2024-01-06 15:44:47

  @Quantz Finally went to fixed green, apparently setup succeeded, then back to red.

 

Retried to locate and connect Deco, back to blinking blue, then red.

Losing my *** time here, TP-Link…

  0  
  0  
#2
Options
Re:Impossible to set-up in new Home office
2024-01-08 07:37:45

  @Quantz 

Hi, Thank you very much for your feedback.

When Deco was red, would you get any IP address under Deco APP>More>Internet Connection>IPV4?

If there is a valid IP address, please refer to this link to change the IPV4 DNS to 8.8.8.8/8.8.4.4.

How to change DNS server settings on my Deco

 

If there is no IP address, or the IP is 0.0.0.0, have you tried to unplug Deco and connect a laptop to the ISP mode to check whether there is any internet connection on the computer?

After that, you could refer to this link to clone the PC MAC address on Deco:

How to Configure MAC Clone on Deco if Deco fails to connect to the internet

Wait for your reply and best regards.

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! ▶Deco X50-5G-V1-1.2.0 Supports WireGuard VPN, Hybrid Mesh and More Try to leave a Message if urgent help is required.
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 216

Replies: 2

Related Articles
Impossible connection
334 0
Best home setup for Garden Office
474 0
Moving to new home! Does the already set up Deco become a plug and play??
6707 0
Set a new password
1026 0
I want to install a new Deco system at my office, how to do that with deco app?
1194 0
How do I set up my home network?
612 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.