Low bandwith over wifi Deco m4
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello,
I use 3 Deco M4R device at my home.
My main Deco is connected to my ISP router, which is using a fiber optic 600MB/30MB line.
When I'm connected to Wi-Fi I get very low speed, it drops to between 50 to 300.
When connected to the LAN port of the Deco I get high speed, 600MB as expected.
Test made when very near to the Deco, same on all three.
I assume this something to do with Wi-Fi configurations.
Can someone assist in figuring this out?
Thanks!!
Roee
I would recommend the following two configuration changes:
1. Configure Deco mesh to run in Access Point mode: Switching a Deco to Access Point (AP) Mode
2. Leave only 5GHz band available on Deco Main Network:
After you've made these changes, run speed tests again, with the device connected over WiFi to Main Deco.