Deco M4 - Connection Preference

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco M4 - Connection Preference

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco M4 - Connection Preference
Deco M4 - Connection Preference
2024-02-11 17:22:56
Model: Deco M4  
Hardware Version: V4
Firmware Version: 1.1.1 Build 20230201 Rel. 37427

Nothing online confirms that the Connection Preference option exists. But after installing ~70 or so mesh systems using the Deco line specifically with M4s.

 

Since the release of v4 and the 'Connection Preference' being enabled. Why has the firmware not been upgraded on the rest of the decos? 

 

The setting seems to be the most basic setting that a mesh network user would likely need, since the whole point of a mesh is to get the best signal possible. 

 

Dec m4 settings

  0      
  0      
#1
Options
1 Reply
Re:Deco M4 - Connection Preference
2024-02-13 08:03:55

  @Alarmtek 

Hi, welcome to the community.

Deco M4_v4 starts supporting "connection preference" since 1.1.0.  While in the release note, it does not mention this feature, instead it says:

New features:
1. Support for customizing Satellite Deco signal source.
2. Support for customizing Clients connection preferences.

Deco M4_v2 supports this feature as well but via beta firmware 1.7.0

Deco M4/S4_V2 Support Connection Preference

 

For other models, you could refer to the firmware release notes here:

Understand the Differences Among Deco Firmware Platforms

Best regards.

 

 

  0  
  0  
#2
Options