This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
after pppoe my lan port 2 and 4 run on 10mbps half duplex but if i put to lan 1 and 3 its going back to 1000mbps full duplex anyone have a solution thank you
Do you mean the issue only happens when your WAN Connection Type is configured as PPPoE? Or the issue is the same when using Dynamic IP etc.?
Besides, in theory, all the LAN ports are the same for AX73, please confirm if you are using the same Ethernet cable and the same wired device when testing LAN1&3. If so, let us know what the model no. of the wired device you are using.
By the way, what is the hardware and firmware version of your AX73?
yap after pppoe in dynamic its normal then i call isp thr dial up not have special request i try to bridge but it same.
the lan cable its same and i connect to ethernet backhaul to ax73 and than i try to computer its same now im using ether 1 and 3. ether 2 and 4 still 10mbps half duplex.
and i have a question can i use switch with lan aggregation from router to switch or just single line cable to switch for ethernet backhaul to ax73 because i just have 2 lan in router?
firmware 1.0.12 ax73 v2
Helpful: 1
Views: 525
Replies: 2
We use cookies and browser activity to improve your experience, personalize content and ads, and analyze how our sites are used. For more details, please read our Privacy Policy.
